This Enfocus PitStop command allows us to change the flatness of the selected vector objects. If none have been selected, this command will affect all susceptible objects.
Flatness is a value in the PDF format coming from the PostScript language that defines the precision with which the RIP should rasterize curved paths, which are decomposed into tiny straight lines.
The relative size of these lines is controlled by assigning the object a flatness value; the lower it is, the smaller the lines are and the more accurate the drawing of the curves as well, but more memory and processing power are needed. Higher values will create fewer and longer lines and the paths will be easier and faster to process. However, if the value is too high, the straight lines might become visible.
The usual value for flatness is "1", but it is not uncommon to find values of "3" or even "8". PitStop allows values between "0.1" and "100".
In this command we can choose a value and establish six conditions with respect to it ("less than…", "greater than…", etc.).
[© Gustavo Sánchez Muñoz, 2024] Gustavo Sánchez Muñoz (also identified as Gusgsm) is the author of the content of this page. Its graphic and written content can be shared, copied and redistributed in whole or in part without the express permission of its author with the only condition that it cannot be used for directly commercial purposes (that is: It cannot be resold, but it can form part as reasonable quotations in commercial works) and the legal terms of any derivative works must be the same as those expressed in this statement. The citation of the source with reference to this site and its author is not mandatory, although it is always appreciated.