This Enfocus PitStop command allows us to change the cap or end of selected vector paths.
There are three options available:
- Butt: The cap ends perpendicularly just at the end point of the path.
- Round: The end has a circular shape with the same diameter as the thickness of the path.
- Projecting: The cap ends projecting just half the width of the thickness of the path.
If no path has been selected, all paths within the scope of the command will be affected.
[© Gustavo Sánchez Muñoz, 2024] Gustavo Sánchez Muñoz (also identified as Gusgsm) is the author of the content of this page. Its graphic and written content can be shared, copied and redistributed in whole or in part without the express permission of its author with the only condition that it cannot be used for directly commercial purposes (that is: It cannot be resold, but it can form part as reasonable quotations in commercial works) and the legal terms of any derivative works must be the same as those expressed in this statement. The citation of the source with reference to this site and its author is not mandatory, although it is always appreciated.