This Enfocus PitStop command allows us to select elements depending on whether their fill overprints or not and if their stroke overprints or not.
By checking each of the two checkboxes we tell PitStop to take this factor into account (ticked) or not (unticked). In the image above, only the overprinting (or not) of the fill of the objects will be taken into account. The overprinting of the stroke will not be evaluated.
Sobreimprime (Overprint).
Cala (Knock out).
If we check the corresponding icon (and it stays pressed down), that means that overprinting must be applied for the object to be selected. If it is not pressed down, the selection will be made if the object does not have overprinting applied (it knocks out); as a summary of possibilities:
-
Select if the fill overprints. -
Select if the fill knocks out. -
Select if the stroke overprints. -
Select if the stroke knocks out.
All non-impossible combinations are allowed.
This command does not take into account the type of overprint ("Mode 0" or "Mode 1"), only if there is overprinting or not.it exists or not.
[© Gustavo Sánchez Muñoz, 2024] Gustavo Sánchez Muñoz (also identified as Gusgsm) is the author of the content of this page. Its graphic and written content can be shared, copied and redistributed in whole or in part without the express permission of its author with the only condition that it cannot be used for directly commercial purposes (that is: It cannot be resold, but it can form part as reasonable quotations in commercial works) and the legal terms of any derivative works must be the same as those expressed in this statement. The citation of the source with reference to this site and its author is not mandatory, although it is always appreciated.